Discovery III

The sternwheeler Discovery III on the Chena River near Fairbanks, Alaska.
History
United States
Builder	Nichols Brothers shipyard, Whidbey Island, Washington
Laid down	1986
Launched	May 31, 1987
Christened	May 9, 1987
In service	July 4, 1987
Homeport	Fairbanks, Alaska
Nickname(s)	"D3"
Status	Active in service
General characteristics
Displacement	280 tons
Length	156 ft (48 m)
Beam	34 ft (10 m)
Draft	3 ft (0.91 m)
Propulsion	(2) 540 hp 12V71 diesel engines by Emerson Diesel powering a hydraulic propulsion system which turns a 20 ft-diameter (6.1 m) paddlewheel.
Capacity	900
Complement	5-9 (Captain, First Mate, Lead Deckhand, 2-6 Deckhands)

Discovery III, built in 1987, is the third of three Discovery sternwheel riverboats operated by the Riverboat Discovery company. Discovery III is still in use as a tour vessel on the Chena and Tanana rivers near Fairbanks, Alaska.

History

Discovery III came into being in 1987 as a result of increased tour traffic to the Riverboat Discovery. Due to increased passenger numbers, the company frequently had to turn away potential guests due to the limited capacity of Discovery II, their primary tour boat. As a result, in 1986 Captain Jim Binkley and his three sons began planning for the construction of a third sternwheeler for the company, which would be named Discovery III.

Plans for Discovery III were finalized by the fall of 1986, and the Binkley family hired the Nichols Brothers Boat Builders, Inc. to build the superstructure of the boat's hulls and decks. Construction began in the late fall of 1986 at the Nichols Brothers shipyard in Whidbey Island, Washington.

Construction of Discovery III was completed 8 months later, in early May 1987. The boat was christened May 9, 1987, in Langley, Washington, and afterward was taken by barge north to the mouth of the Yukon River at St. Marys, Alaska.

Once in St. Marys, the barge was sunk from underneath Discovery III and she began the trip up the Yukon River to Fairbanks, Alaska. In order to make the journey as quickly as possible, Discovery III was driven up the river almost non-stop, with only occasional landings at villages for fuel and brief tours of the vessel by village residents. After a nine-day journey over 1,000 miles up the Yukon River drainage, the Discovery III arrived in Fairbanks on July 3, 1987. She was put into passenger service the following day, on July 4.

Since 1987, Discovery III has been the primary tour vessel operated by the Riverboat Discovery. She makes twice-daily trips throughout the summer from mid-May to mid-September on the Chena and Tanana Rivers.